What should the diagonal pull?
Type the length and width. You get the corner-to-corner pull, a 3-4-5 check, and how far to push the frame if your two pulls differ.
Example numbers. Type your own.
The diagonal should pull
50 ft 0 in corner to corner
600inches corner to corner
30, 40 and 50 ftthe 3-4-5 check
inches out of square
slide one long side to square it
How this was worked out
- Length: 30 ft × 12 + 0 in = 360 in
- Width: 40 ft × 12 + 0 in = 480 in
- Squares: 360 × 360 + 480 × 480 = 129,600 + 230,400 = 360,000
- Diagonal: square root of 360,000 = 600 in = 50 ft 0 in
- 3-4-5 check: 10 × 3, 4 and 5 = 30, 40 and 50 ft
A frame is square when both diagonals pull the same. The feet and inches are the inches rounded to the nearest 1/16. For the 3-4-5 check, mark the first figure along the short side and the second along the long side; the line between the marks should pull the third.
-
About squaring up
A rectangle is square when its two diagonals, corner to corner, read the same on the tape. The figure here comes from the right-triangle rule: multiply the length by itself, do the same with the width, add the two, and take the square root.
To lay out a new one, set two corners first. Hook the tape on one and pull the diagonal figure, then pull the width from the other; where the two tapes cross is the third corner.
The 3-4-5 check is the same rule in a pocket size. Mark 3 feet along one side and 4 along the other, and the gap between the marks should read 5. Use the biggest multiple that fits, because a longer check shows a smaller miss.
When the two pulls differ, the frame is racked. Hold one long side still and slide the other one along its length by the figure shown, the way that makes the long pull shorter, then pull both again. The drawing under the answer shows which side and which way. Keep the tape tight and level, and pull from the same marks each time, outside corner to outside corner. For the dirt under it, see the building pad calculator.