How much soil conditioner do you need?
Measure the beds you are loosening up. You get cubic yards, tons and truck loads of soil conditioner.
You need about
0 cubic yards
0tons
Add your truck size to see loads
for this job
How this was worked out
Assumes soil conditioner at 0.35 tons per cubic yard. Soil weighs more or less with its mix and the water in it, so ask your supplier for their number.
-
About soil conditioner
Soil conditioner is pine fines: pine bark ground and screened down to small bits, from coarse powder up to about half an inch. Worked into hard red clay, it opens the soil up so water soaks in and roots can push through. Spread about 2 to 3 inches over a bed and turn it into the top 6 to 8 inches.
How many dump truck loads do I need?
More about soil conditioner
Pine fines are what is left when a mill screens pine bark for nuggets and mulch, the small stuff that falls through. Yards sell it under several names, including soil conditioner, pine fines and fine pine bark. It is dark brown, light, and smells like a pine woods. It is not compost, though it breaks down slowly into something close to it over a few years.
Clay soil packs so tight that water runs off it and roots stall. Tilling in a few inches of pine fines leaves small air pockets that stay open long after the tiller is gone. Do the whole bed at once, not just the planting holes, or the holes fill with water like a bowl.
Pine bark is a little acidic, which azaleas, camellias, blueberries and hollies like. While the bark breaks down it borrows some nitrogen from the soil, so feed a newly worked bed a little more the first season. It also makes a fine-textured mulch on top of a bed. It is light, so a cubic yard weighs far less than topsoil, and a wet load holds a lot of water.