How much infield mix do you need?
Enter the size of the bare infield you are building or topping up. You get tons, cubic yards and truck loads of infield mix.
You need about
0 tons
0cubic yards
Add your truck size to see loads
for this job
How this was worked out
Assumes infield mix at 1.1 tons per cubic yard. Damp sand weighs more than dry, so ask your supplier for their number.
-
About infield mix
Infield mix in this part of the country is finely crushed red shale, a soft red rock screened small for the bare part of a ballfield. The crushed bits lock together when packed, so the surface stays firm under cleats and sheds rain instead of turning to mud. Ask your yard how deep they lay it on a new field, and top up a worn one a thin layer at a time.
How many dump truck loads do I need?
More about infield mix
Some places sell a blend of sand, silt and clay as infield mix, but the red infield material sold around here is crushed rock, not dirt. The shale is crushed and screened until the pieces are small, and the stone dust from crushing stays in. That dust packs into the gaps between the pieces and lets the surface set up firm. Look at the pile before you buy: it should be small red grit with dust through it, with no big chunks or clods.
Grade the base first so water runs off the infield toward the grass. Spread the crushed shale evenly with a box blade or a rake, then wet it and roll it until a boot heel barely marks it. Fill any low spots and roll again. When adding to an old infield, rake up the top of the old surface first so the new layer grips it instead of sliding off.
To figure the area of the bare part of an infield, measure it as a rough rectangle or a set of them and add the cutouts around the bases. Baked clay drying granules, sometimes sold as infield conditioner, can be spread thin to soak up puddles; they are not the pine bark soil conditioner on this site. Ask your yard what a cubic yard of their infield rock weighs, since a damp load from an open pile weighs more than a dry one.