How much rip rap do you need?
Enter the size of the creek bank, pond edge or spillway you are lining. You get tons, cubic yards and truck loads of rip rap.
You need about
0 tons
0cubic yards
Add your truck size to see loads
for this job
How this was worked out
Assumes rip rap at 1.5 tons per cubic yard. Other gravel weighs a little more or less, so ask your supplier for their number.
-
About rip rap
Rip rap is large broken rock, often about 12 to 24 inches across, piled where moving water would wash soil away. It is the next size up from small rip rap and goes where the water hits harder: creek banks, pond shorelines, spillways and big culvert outlets. A single piece can weigh well over 50 pounds, so it is placed with an excavator or a loader, not by hand.
How many dump truck loads do I need?
More about rip rap
Each state road department sorts rip rap into its own classes by the weight of the stones, and a yard that just says rip rap usually means its middle size. Ask the yard for the size range of the pile before you order, because a load of mostly big pieces covers less ground at the same weight.
Cut the bank back to a slope of about 2 to 1 or flatter, roll out woven filter fabric, and bury the top and bottom edges of the fabric in a trench. Start the rock along the bottom edge of the bank, set each piece so it leans on the ones below it, and work up. The layer should be at least as thick as the biggest stones, which often means 18 inches or more.
Where waves or fast water hit a pond or creek, a layer that is too thin gets picked apart in the first big storm. The gaps between stones are large, so a cubic yard holds a lot of air, and the 1.5 figure here is for loose rock in a truck bed. Rain runs straight off it, so a wet load and a dry load weigh almost the same.