How much block material do you need?
Enter the size of the paver bed, pipe trench or walk you are filling. You get tons, cubic yards and truck loads of block material.
You need about
0 tons
0cubic yards
Add your truck size to see loads
for this job
How this was worked out
Assumes block material at 1.4 tons per cubic yard. Other gravel weighs a little more or less, so ask your supplier for their number.
-
About block material
Block material is fine crushed limestone, smaller than #89 stone and coarser than manufactured sand, about the size of cat litter. Block material is a yard name, not a size on the stone chart, so look at the pile if you are not sure what you are getting. Around the house it makes a firm, level bed under pavers, steps and block, and it tamps down well.
How many dump truck loads do I need?
More about block material
Pick up a handful and the grains run from coarse sand up to small chips about 1/8 inch across, with a little dust mixed in. That small amount of dust is the reason it packs: wet it, run a plate compactor over it, and it sets up firm without the big stones of crusher run poking through the top.
Under a paver patio or a block wall, lay it over a packed base of crusher run, wet it, and drag a straight board across it to level it at an inch or two before setting the first course. It also beds water and sewer pipe in a trench, fills the low spots in an old driveway, and makes a walking path with a firm, even top.
It weighs about the same as crusher run per cubic yard, so the same 1.4 figure works for both. Because it holds some stone dust, a pile left out in the rain soaks up water and weighs more on the scale until it dries. Its grains are smaller than #89 chips and bigger than sand, so say that when you call a yard that does not use the name.