How much crack filler?
Walk the cracks with a tape, measure a typical width and depth. You get gallons, pounds and blocks.
Example numbers. Type your own.
You need about
7.1 gallons of crack filler
68pounds
3blocks of 30 lb
77feet one gallon fills
for the filler
How this was worked out
- One gallon fills: 231 cu in ÷ (0.5 in × 0.5 in × 12) = 77 ft of crack
- Cracks: 500 ft × 12 × 0.5 in × 0.5 in = 1,500 cu in
- 1,500 cu in ÷ 231 cu in a gallon = 6.49 gal
- 6.49 gal × 1.1 (10% extra for waste) = 7.14 gal → 7.1 gal
- 7.14 gal × 9.5 lb a gallon = 67.83 lb
- 67.83 lb ÷ 30 lb a block = 2.26 → 3 blocks of 30 lb, rounded up
A gallon is 231 cubic inches of filler. Blocks and jugs are rounded up, so the job does not come up one short.
-
About crack filling
A crack twice as wide and twice as deep holds four times the filler, so the feet one gallon fills drop fast as cracks open up. A half inch square crack takes 77 feet a gallon. A one inch square crack takes under 20.
Blow or brush the dirt and weeds out before you measure, so the width and depth you type are the real ones. On a deep crack, push a foam rope, called backer rod, down into it first. It takes up room the filler would fill, so type only the depth of filler above the rope.
Hot pour comes in solid blocks that are melted in a kettle and poured hot. Cold pour comes in a jug and goes on straight from it. Read the weight a gallon on your label and type it in.
Fill cracks before you sealcoat, and give the filler time to set first. A crack wider than an inch is too wide for filler. Use the pothole patch calculator for that.