How many yards in a ton of fill dirt?
Type tons or cubic yards of fill dirt, get the other.
That is about
0 cubic yards
1 ton of fill dirt = 0.83 cubic yards
1 cubic yard = 1.2 tons
How this was worked out
Assumes fill dirt at 1.2 tons (2,400 lb) per cubic yard. A ton is 2,000 lb. Wet material weighs more, so ask your supplier for their number.
-
Fill dirt: tons to cubic yards
Tons Cubic yards 1 0.83 2 1.67 3 2.50 4 3.33 5 4.17 6 5.00 7 5.83 8 6.67 9 7.50 10 8.33
-
Weights side by side, dry
Kind Tons per cubic yard Cubic yards per ton Fill dirt 1.2 0.83 Clay fill 1.3 0.77 Chert 1.35 0.74
-
Fill dirt by the ton
Fill dirt is for raising a low yard, backfilling around a foundation, or building up ground before a slab or a shed goes on it. It runs about 1.2 tons per cubic yard dry, so a ton is about 0.83 of a cubic yard. Clay fill and chert are heavier, as the table shows.
Because fill is mostly subsoil and clay, it holds water. A load dug after a wet week can weigh well over the dry figure, and it is harder to pack until it dries out some.
Some pits sell fill by the ton, and many haulers sell it by the truckload, so ask how many yards one of their loads holds. Chert is often sold as compactable fill, the rocky kind that packs hard under drives and pads.
How much fill dirt do you need?