How many sheets of metal roofing?
Type the roof length and the width each sheet covers. You get the full sheets for both sides.
Example numbers. Type your own.
You need about
40 sheets
20on each side
720in of roof length
How this was worked out
- Roof length: 60 ft x 12 = 720 in
- 720 in ÷ 36 in a sheet = 20 sheets a side
- 20 sheets a side x 2 sides = 40 sheets
Each figure is worked from the one printed before it. Sheets are rounded up, so the roof does not come up one short.
-
About metal roof sheets
A metal sheet covers less than its full width, because each edge laps over the sheet next to it. The width it covers once lapped is the number to type. 36 in is common.
The sheets run from the peak down to the eave, the low edge of the roof, side by side along the roof. So the roof length, end to end, decides how many fit. Add any overhang past the end walls.
This counts both slopes of a plain roof with two sides that meet at the peak.
It does not work out how long each sheet is. That comes from the width of the building and how steep the roof is.
Trim, ridge cap, screws and door openings are not counted.
Check the sheet cover and the lengths with your supplier before you order.