How much sealer for a driveway or lot?
Measure the area, pick the sealer and the coats. You get gallons, water, sand, pails and drums.
Example numbers. Type your own.
You need about
191 gallons of sealer
395-gallon pails
455-gallon drums
38gallons of water
477pounds of sand
for the sealer
How this was worked out
- Area: 200 ft × 50 ft = 10,000 sq ft
- One coat: 10,000 sq ft ÷ 110 sq ft a gallon = 90.9 gal
- 90.9 gal × 2 coats = 181.8 gal
- 181.8 gal × 1.05 (5% extra for waste) = 191 gal of sealer
- Water: 190.9 gal × 20 ÷ 100 = 38.2 gal
- Mixed: 190.9 gal + 38.2 gal of water = about 229 gal to spread
- Sand: 190.9 gal × 250 lb ÷ 100 = 477 lb
- 191 gal ÷ 5 = 39 pails, or ÷ 55 = 4 drums
Gallons are of sealer as it comes, before water or sand. Pails and drums are rounded up, so the job does not come up one short.
-
About sealcoating
The coverage box is for one gallon of sealer as it comes in the pail or drum, before any water or sand goes in. Some labels give the coverage after mixing, which is a smaller number because the water spreads it out. Type the number for sealer as it comes in the drum.
Two coats is the usual job, with a third on the drive lanes where tires wear it most. Seal at 50 F and rising, with no night under 50 F in the day after. It dries in a few hours, but keep cars off it for a full day. New asphalt needs a month or more to cure before its first coat.
Fill the cracks first, or the sealer runs into them and they keep spreading. The other asphalt jobs are on the Asphalt page.
A pail of driveway sealer from the store is a thinner, ready-to-use mix, and the coverage printed on its label wins over the number here. Some towns and states do not allow coal tar sealer, so check your local rules.