How much stone and asphalt for a chip seal?
Measure the road or drive and pick the chip size. You get tons of stone, gallons of asphalt and the loads.
Example numbers. Type your own.
You need about
14.6 tons of chip stone
385gallons of asphalt to shoot
1truck load, 66% full
1,111square yards
for the stone
How this was worked out
- Area: 500 ft × 20 ft = 10,000 sq ft ÷ 9 = 1,111.11 sq yd
- Stone: 10,000 sq ft ÷ 9 × 25 lb a sq yd ÷ 2,000 = 13.89 tons
- 13.89 tons × 1.05 (5% extra for waste) = 14.5845 tons → 14.6 tons
- 14.6 tons ÷ 22 tons a truck = 0.66 → 1 truck load, 66% full
- Asphalt shot: 10,000 sq ft ÷ 9 × 0.33 gal a sq yd × 1.05 = 385 gal of asphalt
The rates start at the middle of a state spec's ranges. Truck loads carry the stone and round up to whole trucks.
-
About chip seal
A chip seal, also called tar and gravel, is a coat of liquid asphalt sprayed on the road (crews call the spray the shot) with clean stone chips spread over it and rolled in while it is still wet. It is the low-cost surface for country roads and long drives.
Bigger chips stand taller, so each square yard takes more stone and a heavier spray to hold it. The two rate boxes start at the middle of the ranges one state's road spec gives for each stone size. That match of size to rate is our best reading of the table, so check both numbers against your plan or supplier before you order.
A double chip seal is two rounds: work this out once for the bottom layer, then again for the top. Sweep up the loose chips after a few days of traffic. Lay it only in warm, dry weather, because the asphalt needs heat to grab the stone.
For hot mix paving and upkeep, start from the calculators on the Asphalt page.